Cold Water and Booster Pump Repair, Maintenance and Service
Fault diagnosis, pressure adjustment, maintenance, repair and replacement of booster (hydrophore) and cold water pressure pumps.
A booster (hydrophore) system delivers water to the upper floors at the required pressure in buildings where mains pressure is not enough. When it fails, taps run weakly, pressure fluctuates constantly, or the pump keeps switching on and off.
We diagnose, maintain, repair and replace booster and cold water pumps in apartments, housing complexes, workplaces and private homes in Kayseri. Along with the pump, we check the expansion tank, pressure switch, check valve and control panel, because many booster faults come from these components rather than from the pump itself.
Booster switching on and off frequently
The most common reason for a pump that keeps starting and stopping at short intervals is low pre-charge pressure in the expansion tank or a torn tank membrane. A leak in the installation or a faulty check valve gives the same symptom. Because this wears the pump quickly, early action matters.
Low pressure
Weak flow on the upper floors can be caused by an incorrectly set pressure switch, a pump that is too small for the building, or air or a blockage in the suction line. We take measurements on site to find the source of the problem.
Periodic maintenance
Regular booster maintenance covers tank pressure, switch settings, pump sealing and electrical connections. In multi-storey buildings in particular, planned maintenance reduces the risk of the building running out of water.
Key Features
- Booster pump fault diagnosis
- Pressure switch adjustment and replacement
- Expansion tank pre-charge check
- Check valve and fitting inspection
- Booster pump replacement
Frequently Asked Questions
The booster keeps starting and stopping. What could be the cause?
The most frequent cause is pressure loss in the expansion tank or a membrane failure. Leaks in the installation and a faulty check valve can also cause this.
Water pressure in the building is low. Does the booster need replacing?
Not always. In many cases the problem can be solved by checking the pressure switch setting, tank pressure or suction line. If the pump capacity is not sufficient for the building, replacement is recommended.
Do you service boosters in private homes?
Yes, in addition to apartments and workplaces, we service booster and water pumps in private homes.